Weather-guard Model 1908 PROTECT-A-RAIL® Heavy Duty Cab Protecto Manuel d'utilisateur télécharger pdf

ASSEMBLY, WIRING, and SEALANT INSTRUCTIONS

HEAVY-DUTY PROTECT-A-RAIL 1908

Part No. 24-0148 REV. B ECN 5315 05/13

PARTS LIST

1 Lower Protect-A-Rail Section

1 Upper Protect-A-Rail Section

HARDWARE KIT

4 3/8-16 x 3" Hex Head Bolt

4 3/8-16 Nylon Lock Nut

8 3/8 Flat Washer

1 Tube (Black Adhesive Sealant)

2 Red Cap

2 Square Plastic Plug

6 7/16 Dia. Plastic Snap-In Bushing

2 7/8 Dia. Plastic Plugs

1 Tube (Cap Adhesive)

TOOLS REQUIRED

 1/2" Open or Box End Wrench

 9/16" Open or Box End Wrench (2)

 Electric Drill w/ 1/8" and 7/16" bits

If wiring is desired on

the side areas, drill a

7/16" dia. hole 5/8"

below the 1" x 2" tube.

NOTE:

Extra snap bushings

have been provided

for any wiring holes

(7/16" dia.) that are

added.

Select the desired height of the Protect-A-Rail for your vehicle and install the four 3/8-16 x 3" fasteners. If you are install-

ing any accessories that require wiring, two snap bushing have been installed internally to protect the wiring. Any addi-

tional holes that are added will have to have snap bushings also to protect the wiring. In the bottom of the unit you will

need to install two 7/8" dia. plugs. To install wiring drill a 1/8" dia. hole in the center of the plug(s). Depending on the

quantity and size of the wires this hole may have to be larger. The illustration below shows the open pathways for the

wire. After wiring has been installed, insert the two square plugs into the top openings. Next apply a couple of drops of

the cap adhesive (1/4 oz. tube) to the inside of the red caps and slide them down over the top of the tubes with the

square plugs.

7/8" dia.

Plug

Square Plug

Red Cap

CAUTION

To keep debris out of your

eyes when drilling, always

wear protective eyewear.

3/8-16 x 3"

Fasteners

1 2

Résumé du contenu

Page 1 - TOOLS REQUIRED

ASSEMBLY, WIRING, and SEALANT INSTRUCTIONSHEAVY-DUTY PROTECT-A-RAIL 1908Part No. 24-0148 REV. B ECN 5315 05/13PARTS LIST1 Lower Protect-A-Rail Sectio

Page 2 - - NOTICE

2After the unit is completely wired and all fasteners are tight, you will need to apply the sealant (3 to 4 oz. tube) to allfasteners, wiring holes, a

Commentaires sur ces manuels

Pas de commentaire

Weather-guard Model 1908 PROTECT-A-RAIL® Heavy Duty Cab Protecto Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Weather-guard Model 1908 PROTECT-A-RAIL® Heavy Duty Cab Protecto. WEATHER GUARD Model 1908 PROTECT-A-RAIL® Heavy Duty Cab Protector, Steel User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Weather-guard Model 1908 PROTECT-A-RAIL® Heavy Duty Cab Protecto