1Read and understand all WARNINGS, DANGERS, NOTICES and instructions before assembly and installation.This product is only intended and only safe for
10STEP 9Place the Ladder Stop (A) on top of the Cross-Member (B) and install the 5/16-18 x 2-1/4" Fastener (Flat Hd. Screw).(A)5/16" Flat Wa
11(3) 3/8" Flat Washer5/16-18 x 4-1/2" Hex Hd. Bolt(A)STEP 10Insert Aluminum Bushing (A) into the Rear Cross-Member (B). Attach back of Cyli
12FRONT TO REAR DRIVE TUBE ASSEMBLYSTEP 12Match the front to rear length to the length of the Model 280. Install 5/16-18 x 2" Fasteners (Tighten
13STEP 15Slide Lower Handle Section (A) into Upper Handle Section (B) and locate desired handle length. Align holes and insert 1-1/2" Clevis Pin
14STEP 19With the side of the ladder sitting on the ladder support of the rear slide down assembly in the up position, adjust the ladder stop so that
15Product fits based on vehicle design available at the revision date. Vehicle manufacturers may change specs after the revision date, so if you have
2Front Rotation AssemblyQty. 1Rear Rotation AssemblyQty. 1Driveshaft/Handle AssemblyQty. 1Lower Handle SectionQty. 1Upper Handle SectionQty. 1Cylinder
3FASTENER CHARTAluminum BushingCotter PinClevis Pin (1")Clevis Pin (1-1/2")5/16-18 Nylon Lock NutFlat Plastic Bushing3/8-16 Nylon Lock Nut5/
4REAR ROTATION ASSEMBLY
5STEP 2 Install the 5/16-18 x 1" Fastener as shown.(A)(B)STEP 1 Use the supplied lubricant and coat the pre-assembled Black Plastic Bushing (A).
6STEP 3 Slide a White Plastic Bushing (A) onto the Driveshaft/Handle Assembly (B) until it is butted up to the Cross-Member (C). Align holes in the tu
7FRONT ROTATION ASSEMBLY
8(A)(B)(A)(B)(C)(D)STEP 5 Use the supplied lubricant and coat the pre-assembled Black Plastic Bushing (A). Insert the Front Drive Tube (B) into the l
9(A)(B)(B)5/16-18 x 2-3/4" Hex Hd. Bolt(2) 5/16" Flat Washer5/16-18 Nylon Lock Nut(A)3/8-16 x 2-1/4" Hex Hd. Bolt(2) 3/8" FlatWash
Commentaires sur ces manuels