Weather-guard Model 254 EZ-GLIDE® Clamp Kit, Universal, Driver S Manuel d'utilisateur télécharger pdf

Read and understand all instructions and warnings before operating or using this product.

This product is only intended and only safe for transporting ladders. It is the responsibility of the user to secure these

materials to the rack before transporting.

Ladders must be secured per ANSI standard A142.2-1990 paragraph 8.4.4. Ladder damage will occur from road shock

and vehicle vibration if the ladder is not properly secured to the ladder rack. Bouncing and side to side motion of an

improperly secured ladder will cause wear and weaken the ladder. Using a damaged ladder could lead to structural col-

lapse resulting in serious injury or death. Place ladder in a raised position before transporting. Driving with rack in lowered

position may cause serious injury or damage to vehicle, ladder, rack or persons.

Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer dis-

claims all liability for injuries to persons or property resulting from any modification to, or unintended use of this product.

Never load your rack to exceed the safe capacity of your vehicle. Heavy loads when carried high can dangerously alter the

center of gravity.

Loads should be approximately centered front to rear. Failure to do this will cause damage to the vehicle roof. Long loads

that extend out the rear of the vehicle will prevent the rear hatch from fully opening and cause damage if attempted.

WARNING

–ATTENTION–

–NOTICE–

CAUTION

ASSEMBLY INSTRUCTIONS

MODEL 254 EZ-GLIDE

™

SYSTEM

DRIVER SIDE CLAMP KIT

TOOLS REQUIRED

• 1/2" Open or Box End Wrench

• 3/8" Drive Socket (1/2")

• 3/8" Drive Ratchet

• 3/32" Allen Wrench

PARTS LIST

See Page 2

• Front Rail

• Rear Rail

• Rail Connector

• Pivot Tube Bracket

• Front Ladder Stop

• Handle

• Rear Ladder Clamp

• Handle Pivot Tube

1 Clamp Down Kit

4 5/16-18 x 1" Hex Hd. Bolt

13 5/16-18 Nylon Lock Nut

20 5/16" Flat W

asher

2 5/16-18 x 2" Hex Hd. Bolt

4 5/16-18 x 2-3/4" Hex Hd. Bolt

2 Bushing (see page 2)

1 Cotter Pin

2 5/16-18 x 2-1/2" Carriage Bolt

1 5/16-18 x 2-1/2" Hex Hd. Bolt

1 Handle Pivot Ball W/Allen Screw

(see page 2)

HARDWARE KIT

See Page 3

Check these kits to be sure the following parts are included.

Approximate assembly and Installation time:

30 min. per unit (1/2 hr.) depending on van equipment and installer experience.

IMPORTANT BEFORE YOU BEGIN

Read these instructions and warnings completely before installation.

Part No. 24-0109 REV. D ECN 5315 0505/13

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1

Read and understand all instructions and warnings before operating or using this product.This product is only intended and only safe for transporting

Page 2

Front RailQty. 1Rear RailQty. 1Rail ConnectorQty. 1Pivot Tube BracketQty. 1Front Ladder StopQty. 1HandleQty. 1Rear Ladder ClampQty. 1Handle Pivot Tube

Page 3 - FASTENER CHART

34 5/16 18 x 2 3/4 Hex Hd. Bolt2 Bushing (See Page 2)1 Cotter Pin2 5/16-18 x 2-1/2" Carriage Bolt1 5/16-18 x 2-1/2" Hex Hd. Bolt1 Handle Pi

Page 4

REAR CLAMP ASSEMBLYSTEP 1Install Cotter Pin (A) into Handle Pivot Tube (B)and slide on Plastic Bushing (C)(A)(B)(C)STEP 2Insert Handle Pivot Tube (A)i

Page 5

STEP 3Insert the Handle (A) into the Handle Pivot Tube (B) through the Handle Pivot Ball W/Allen Screw (C). Turn the allen screwinto the ball, making

Page 6

STEP 6Slide the Rail Connector (A) over the end of the Rear Rail(B) as shown. Install a 5/16-18 x 1" Fastener.(Do not tighten at this time.)(A)(B

Page 7 - FINAL ASSEMBLY

FINAL ASSEMBLY7

Page 8 - REPLACEMENT PARTS

Product fits based on vehicle design available at the revision date. Vehicle manufacturers may change specs after the revision date, so if you have a

Commentaires sur ces manuels

Pas de commentaire

Weather-guard Model 254 EZ-GLIDE® Clamp Kit, Universal, Driver S Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Weather-guard Model 254 EZ-GLIDE® Clamp Kit, Universal, Driver S. WEATHER GUARD Model 254 EZ-GLIDE® Clamp Kit, Universal, Driver Side User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Weather-guard Model 254 EZ-GLIDE® Clamp Kit, Universal, Driver S